THE GENERAL USE OF HVLP PAINT SPRAYER

The HVLP paint sprayer is also called high volume low pressure. It is the best form of refinishing. In every professional paint shop, you would observe that they use an HVLP paint sprayer for their work. It is actually the standard for the industry. The paint sprayer is divided into two; the low air pressure and a high volume pressure volume of paint. The HVLP paint sprayer goes on in a mist which implies good coverage on the paint. There is however a technique to how to use the HVLP paint sprayer in order to produce an outstanding paint job on the pickleball court

Step 1- Using the compressor

In using the HVLP paint sprayer, switching on the air compressor that powers it is one of the first thing to do. Then you set the air pressure to 90 psi at the hose end. The HVLP paint sprayer has its own pressure regulator. You might not need to set the mouth of the gun so high, so there is room to adjust it. Especially, for a pickleball court which requires painstaking attention. It is important to use the manufacturer’s manual for HVLP paint sprayer. You can start with 50 psi and thereafter make adjustments from there.  

Step 2- Connecting the Sprayer

Once the compressor is on, then the HVLP can then be attached to the hose. Upon doing this, press down on the trigger of the sprayer. Then keep holding the sprayer until the fluctuation at the gun’s base ends. At that stage, you are ready to put the paint into the container. The manufacturer’s manual comes in handy here to determine how much you need to limit the paint for spraying. Hook the container to the sprayer.

Immediately you start spraying, do not spray the surface of the pickleball court. Instead, start by spraying the lines. You then need to adjust the fan which is on the back of the sprayer in order to achieve the type of spray you desire. If the paint is running, speed up the fan and properly adjust.

Step 3- Knowing the Technique

Once the fan is properly adjusted, you then need to make changes to the fluid control of your HVLP paint sprayer. Ideally, you need a quantity of paint that is heavy enough to be solid, however it must not be too much. By proper practicing, you will understand how to achieve this. Hold the sprayer between 6 inches and 8 inches from the surface of the pickleball court you want to paint. It is important that you hold the sprayer perpendicular to the surface of the court area

Step 4- Doing the Painting

In doing the painting, you need to keep the HVLP paint sprayer to move horizontally. If you focus on one part for more than a few seconds, then the paint will begin to run off the lines. That is why it is important to start from the topmost part of the lines of the court and later continue the sweep for a few inches more to create a perfect effect.

PICKLEBALL COURT

The pickleball court is likened to a badminton court. It is almost the same size with a badminton court too. It measures 20×44 feet. In pickleball, the same court is used for both single and double player. The net height in a pickleball is 36 inches at the side-lines and 34 inches in the middle. The court is similar to a tennis court with a right and left service courts and a 7-foot non volley zone in front of the net which is sometimes referred to as the kitchen. The court is constructed specifically for pickleball or they can be converted using existing tennis or badminton courts. 

An HVLP paint sprayer is a device used to spray paint at a pressure that is easy to control and direct. That is why using it for a pickleball court which requires paying attention to details is important. Using the HVLP paint sprayer produces a fine, smooth, and consistent finished paint surfaces that cannot be achieved by any other tool. However, it is unfortunate that people do not learn to operate it.

It can be frustrating when they become unable to get the intended result and outcome on the pickleball court when they use the HVLP paint sprayer. Hence this leads many painters to conclude either the device is to blame, or HVLP sprayers aren’t as great painting tools as they are said to be. that is why it is necessary to read up on this topic “How to use HVLP paint sprayer to paint a pickleball court”

The Principle of Operation of the HVLP Paint Sprayers Work

The process whereby the HVLP paint sprayers turn liquid paint into hundreds of thousands of tiny droplets is called atomization. The atomized droplets allow the paint to be spread in almost to a molecular level on the surface of the work piece.

The HVLP paint sprayer has various components that work together as a whole. The HVLP paint sprayers guns are the latest spray technology and therefore the most efficient. Other past technologies are pressured and with gravity feed sprayers.

In the pressure guns containing the paints, the fluid was pressurized and then allowed to flow out through a small opening, controlled mostly by a valve that could be actuated by hand. The paint sprayer is such that the flow of air past the reservoir, create a low pressure that sucks and push out the paint and then splits it into small particles as it exits from the opening through which the paint comes out from. 

The gravity feed guns is mounted on the top of the sprayer. It takes advantage of the force of gravity to draw the paint downwards where it combines with a high speed exiting jet.

Performance

The HVLP paint sprayers are either siphon or gravity-feed designs. They are unique in that they work at low pressures. The pressure is typically 10 psi to 20 psi. They are cable of spraying a significantly in large volume of paint with minimal waste (this also happens to be their major strength). Their ability to transfer large ratios of paint to work surface and having minimal overspray means that HVLP sprayers can be used where efficiency and accuracy are highly preferable.

The reservoir of the HVLP main job is to hold the paint and allow the atmospheric condition to pressure it to act on the paint. It allows it to flow downwards by gravity. Most HVLP paint have reservoirs that can contain up to a quart of paint while the gravity-feed reservoirs hold up to a pint of paint. The atmospheric pressure is able to act on the paint through a non-spill valve or ventilation.  

Settings

In operating the HVLP paint sprayer, there are three things to remember; the air pressure, the paint flow, and the fan size. The air pressure should be paid attention to, in fact manufacturer’s recommend 30 psi to 50 psi. In the event that you intend to use a greater air pressure than what is being atomize the paint more, know that it would definitely cause an overspray. Over atomization also increases the “orange peel” phenomenon because the solvents in the paint dry much faster than the paint pigments.

The function of the fan is to determine how wide the paint spray pattern would be. using a wide fan means that the amount of material distributed decreases. That means that you may need to spray the same area more than once or twice in order to get desired result and finish

It is also possible to adjust the paint flow, and you only need to vary it depending on the specific paint you are using. Once you have set it, it should remain unchanged until you install a different air needle or air cap.

The Aircap is the final component that helps to determine how to spray the paint especially if tou are doing on a pickleball court, the aircap has holes drilled with precision and placed in such a way that will produce the best pattern on the paint surface. Air entering these holes atomizes the paint and creates a pattern that has a fan’s shape.

The setting of the HVLP paint sprayer having noted the features mentioned above, you still need to prepare the paint to the desired quality and do a few tests with a different setting. Once you get the pattern you want, you can then set the paint and you will never go wrong in having a perfect pickleball court with the proper use of your HVLP paint sprayer

THE BEST PICKLEBALL NET

Going for a net that is expensive is not a wise thing, because the best and most valuable pickleball net are not the one that are expensive. It is simply going for the one that has a decent quality when presented with a choice, cost does not mean quality and whilst everyone will be looking for different features in their purchase, however going for a net that is well constructed and will last for years matters more.

We have portable net, and the best is the Picklenet by Oncourt Offcourt.however, this is based on value. However, the Swiftnet by Pickleball Inc is also making waves as a very valuable pickleball net. The net stands out from the rest on the market in that it is a totally unique design. Considering the carbon fiber, they have managed to cut the weight to a mere 14 lbs. it is also very easy to set up. The main challenge is the price, it costs over twice as much. Hence, it is not the best pickleball net simply based on that factor. Since our average reader probably does not want to shell out that much.

Below are a few things to look out for when making your decision.

Here are the things to consider before making choice

  • Stability of the pickleball net. It will keep on falling over from gust of wind if it is not stable
  • A pickleball net would sag in the middle if it does not have enough support. If it sags it defeats the purpose and it wold look unpresentable and unprofessional.
  • Plastic nets or nets made from low quality materials are much more likely to break, especially over time.

Approved Pickleball Net Specifications

Pickleball Net Dimensions:  

The net should have a total width of at least 20 feet. Standard nets are 22′ long to cover the 20′ wide court, plus one foot of net on each side as net posts must be 12″ from the sideline.

Pickleball Net Height

Should be 36 inches (0.914 m)at the sideline and 34 inches (0.86 m) at the center.

  • Center strap may be used, if needed, to keep the net taut at standard 34″ height.
  • Mesh size of the netting should be sufficiently small to prevent standard pickleball ball from passing through the net.
  • The top band of the net should be edged with a 2 inch (5.1 cm) white binding over a cord or cable running through the binding.
  • Posts: Net posts should be placed outside the sidelines. Recommended placement is 12 inches (30.48 cm) from the sideline.

However, it is important to consider the convenience, lightweight design and quality construction could be well worth it and something to consider for a serious pickleball player.

But before you purchase a net, let’s quickly review the specifications of a USAPA (official pickleball association) regulation net to make sure you pick the right one.

It is recommended to go for an official size pickleball net If you are going to invest in owning a net, Although you can save some money on a cheap, “starter” net, I would totally avoid these if you are serious about playing pickleball. 

According to Amazon, the Portable Pickleball Net System as 5 star, which is a huge indication as to the quality and suitability of this net.  Also, this is an excellent net and one I think that anyone would be happy to play with, day after day and indoors & outdoors.  The lightweight makes it very portable and the stability means that you can play even in windy conditions and it is excellent net and superb price